Navigation Contact Us Phone Us

Don’t Replace A ‘Pressed-In’ Ball Joint More Than Once.

Date: 24th November, 2021

 

 

 

Did You Know?

 

Never Replace A ‘Pressed-In’ Ball Joint More Than Once.


For driver safety, it is recommended that a ‘press-in’ ball joint is only replaced on one occasion and that any subsequent repair should use a fully assembled wishbone arm.  
 
It is important to note that ball joints cannot be indefinitely replaced. Repetitive dismantling/ pressing operations significantly affect both the diameter and roundness of the arm body hole - where the ball joint is pressed in. This is especially the case when the arm body material is sheet steel.
 
 
 
 
Media Library - ball joint news 1
 
 
Media Library - ball joint news 2
Don’t Replace A ‘Pressed-In’ Ball Joint More Than Once.

More News

12May

Brand new DMF locked? Tips from LuK

29Apr

Lambda Sensor Damages by Oil

22Apr

DS software update Coming Soon!

News Archive

 

Antispam Code Cannot read this code: Change
Processing
All rights reserved © 2022 qualvecom.com
Web Development by KL Studios

Please Wait

Please Wait
close
Scroll to Top

This website wishes to use third-party cookies to ensure that you have the best possible experience. If you'd like to accept the use of these cookies, you can do so below. Please note that not accepting third-party cookies can disrupt the website experience. Full details and controls are available in our cookie policy with further details available in our privacy statement.

Accept Selection Accept All